I recently switched over to CH exclusively on roofs, and amazed at how much easier it is to use, mix and handle. The picture attached is in a community of Garden Homes. I have done approximately 20 homes on this one street over the past 2.5 weeks. Any white haze on the roofs have been rinsed off with the recent rains. However, this one roof has a section that has not wased away. With the SH, it always rinsed off with any rain at all.
Any ideas that you guys have used in situations like this? This last coat was a final touch up on a bad section. My mistake was not rinsing down the roof again after the initial rinse to cool the roof. It was 85+ degrees (hot-lanta).
It will rinse with the rain. I've never had luck going back and trying to rinse with garden hose. When you do multiple coats you are doubling or tripling the amount of residue. With very dirty roofs you are better off going with a stronger mix on the first coat or augmenting with SH.
I recently switched over to CH exclusively on roofs, and amazed at how much easier it is to use, mix and handle. The picture attached is in a community of Garden Homes. I have done approximately 20 homes on this one street over the past 2.5 weeks. Any white haze on the roofs have been rinsed off with the recent rains. However, this one roof has a section that has not wased away. With the SH, it always rinsed off with any rain at all.
Any ideas that you guys have used in situations like this? This last coat was a final touch up on a bad section. My mistake was not rinsing down the roof again after the initial rinse to cool the roof. It was 85+ degrees (hot-lanta).
I'm trying to keep the referrals rolling in!
Gary - Tim is absolutely spot on - it will indeed rinse with rain. Make sure and set your customer's expectations when you sell that there will be some light white powder that will rinse after the first couple rains. If you feel like you are in a pinch and want to clean this stuff off this roof just to appease your customer, you can spray a diluted down mix of vinegar or "truck-wash" and you'll see the residue foam up white and dissolve. Then a light rinse will get rid of it.
__________________
Brandon Vaughn
All-Clean! SoftWash Gresham, OR brandon@allcleansoftwash.com www.allcleansoftwash.com 503.887.6404
what ratio of vinegar do you use and which truck wash have you tried? Our biggest challenge is rinsing the residue off flat surfaces and the solid stained decks and the dark repainted flat aluminum siding.
just make sure to rinse and then rinse again, if using a truck wash soap. Most are sodium hydroxide based, which is a degreaser, and can start to break down the oil/asphalt based shingles if not rinsed properly. Especially in hot weather.
Two Stepping soap is what you need. It is actually acid based. It will remove the haze from anything the CH sticks to. It is used in the fleet wash industry. However I'd just let it rain some more.
i get that on tile roofs when i clean them.....i always let the customer know that it will wash off with 2-3 HARD rains. (not light rains) It comes off no problem
I went out yesterday and tried Brandon's idea with the vinegar mix. We also had a heavy rain blow in last night. I will be out there tomorrow on another job and will check the status of the white haze.
__________________
Soft Wash - Atlanta, Gary P. Gelatt Owner cleanmyroof-atl.com gary.softwash@gmail.com 770-310-8530 1029 Gate Post Lane, Lawrenceville, GA 30044
Tim I use Landa Supernova which is sulfuric acid based truck wash. Also use it to brighten aluminum at higher concentrations.
Ratio is 20:1 or more. It is very concentrated. You'll see the CH residue literally foam up and dissolve away. It has saved my bacon on a couple jobs where I rushed too much and left residue behind.
I use vinegar at a 50:50 ratio on more delicate surfaces, brush and rinse.
__________________
Brandon Vaughn
All-Clean! SoftWash Gresham, OR brandon@allcleansoftwash.com www.allcleansoftwash.com 503.887.6404
Tim I use Landa Supernova which is sulfuric acid based truck wash. Also use it to brighten aluminum at higher concentrations.
Ratio is 20:1 or more. It is very concentrated. You'll see the CH residue literally foam up and dissolve away. It has saved my bacon on a couple jobs where I rushed too much and left residue behind.
I use vinegar at a 50:50 ratio on more delicate surfaces, brush and rinse.
EXACTLY! I just couldn't remember the name of that soap Brandon.